|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
ENGLISH
English
Connections
Before connecting this unit to the amplifier (or receiver), observe the following carefully. � Turn off the amplifier. � Make all connections before plugging in this unit.
� DO NOT connect this unit to the REC OUT jacks of your amplifier. It may damage your subwoofer.
Monaural audio cord (Supplied) Amplifier or Receiver
To LINE OUT
To SUBWOOFER OUT or MONO To an AC outlet SP-PWE5 Stereo audio cord (not Supplied) In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal. SP-DWF10 To an AC outlet
Operations
SP-PWE5 (Front) SP-PWE5 (Rear) SP-DWF10 (Front) SP-DWF10 (Rear)
Rear view
Power lamp
Power lamp
Turning On the Power�POWER
To turn on the power. Press the POWER switch to the [ � or � The power lamp lights in green.
SP-PWE5
POWER
ON OFF
Operating the Unit Automatically According to the Incoming Signals�AUTO POWER ON/STANDBY
To activate AUTO POWER ON/STANDBY. Press the AUTO POWER ON/STANDBY switch to the [ position. � If no sound comes in for 5-10 minutes, the unit enters standby mode. The power lamp lights in red. � If the unit detects incoming signals, the unit starts operating. The power lamp lights in green. To cancel AUTO POWER ON/STANDBY. Press out the AUTO POWER ON/STANDBY switch to set it to the [ ] CANCEL position.
AUTO POWER ON / STANDBY
ON CANCEL
] ON position.
SP-DWF10
] ON
To cut of the power. Press the POWER switch to the [ � or � The power lamp goes out. � This will disconnect the mains lead.
SP-PWE5
POWER
] OFF position.
SP-DWF10
ON
OFF
When the volume level of the amplifier is so low or the incoming signals are so weak that this unit cannot detect sounds, Auto Power On/Standby may not work correctly.
�8�
|
|
|
> |
|
