|
Who's Online
There currently are 5918 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great manual, great price. Has a few of the basic operating instructions that most service manuals leave out. Complete instructions for disassembling board by board, safety precautions, schematics, complete parts list.
;
I am very pleased with the service manual for my RT-909. This was an easy purchase and great procuct, and much cheaper than other venues i had looked at. This web site is now listed in my favorites list. KEEP UP THE GOOD WORK. THANKS. J. BROWN
;
A very well written and easy to understand manual.
;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
Note: Step4, 5 is to check if CPU software is capable of DSP code. �Software Type No� is to show what �DSP Code Group� CPU is capable of. And vice versa. Step 8 is to manage the 16 codes for DSP. � When the unit is once turned into Service Mode, the unit keeps this mode until the main power is turned off. (Turning into stand-by mode does not make it quit from Service Mode.) When the unit quits from Service Mode, Information in the memory is also cleared and the unit returns to the status when it is out from the factory. Product Reset To reset the back up memory of the unit into the default status, follow the procedure below. 1. 2. Turn of the unit and press 7.1CH INPUT and MULTI button simultaneously more than 1.5 seconds. After �DEFAULT� is displayed on FLD, power is turned off once and turned of again, EEPROM is cleared to the default status, µ-com is reset and the unit returns to the normal status. (Software Serial Number will not be cleared.) Note: When the unit is shipped from the factory, the procedure above must be done to set the unit to initial status after the tests.
Personal notes:
7
|
|
|
> |
|