|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm so glad I was able to find a site to download my missing manuals. Very reasonable prices and they kept me informed about the process and I had my manual within less than a day. The only thing I wish was an option is a 100% English version with no spanish or anything. But overall great site.
;
The manual is complete with excellent quality! One suggestion, show number of pages and weather it is multi-lingual. The AD 600 Manuel is about 76 pages and over half is non English. This results in a larger print job than usually needed. Having this information, one could select the desired pages for printing.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
Consult your speaker and driver manufacturer's specifications for the
SR Crossover
SETUP
3
**CAUTION: DO NOT TURN ON THE POWER AMPLIFIERS YET. recommended crossover frequencies. crossovers are as follows:
Basic setup procedures for the
� Label each power amplifier for its respective frequency band. SR834: LOW, MID, or HIGH for stereo operation; LOW, LOW-MID, HIGH-MID, or HIGH for mono operation. SR823: LOW, HIGH for stereo operation or LOW, MID, HIGH for mono operation. � Set each power amplifier volume control at maximum and connect each power amplifier output to its correct speaker or driver. � Apply power to the crossover. Apply power to the mixer then the power amps.
STEREO OPERATION
Using the markings non-italicized markings on the front and rear panels and set each channel as follows: � Set the gain control to 0 dB. Set all level controls to -12 and switch in the 15Hz high-pass filter if desired. SR823: Set the LOW/HIGH crossover frequency for each channel according to the front panel markings. If below 180Hz is desired, press the ÷10 switch** on the rear panel. SR834: Set the LOW/MID crossover frequency for each channel according to the front panel markings. If below 180Hz is desired, press the ÷10 switch** on the rear panel. If the desired frequency is below 180 Hz, the ÷10 switch must be engaged (LED indicator lit). If the desired frequency is above 180 Hz, the Range switch must be disengaged (LED indicator off). When the ÷10 switch is engaged, the frequencies marked around the LOW/MID (LOW/HIGH for SR823) frequency control are divided by 10. In other words, if the LOW/MID (LOW/HIGH for SR823) frequency is set at 250Hz and the range switch is engaged, the actual crossover frequency is 25Hz. SR834: Set the MID/HIGH crossover frequency. The Channel 2 MID/HIGH frequency control has two sets of markings. When using the crossover in stereo mode, use the lower frequency markings to set the MID/HIGH crossover point. This frequency control has no range switch. WARNING: BEFORE PRESSING THE ÷10, LF SUM OR STEREO/MONO SWITCHES, LOWER THE OUTPUTS OF YOUR POWER AMPLIFIERS TO AVOID DAMAGE TO DRIVERS AND LOUDSPEAKERS.
|
|
|
> |
|
