|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good price, very legible manual, exactly what I needed -- but had to wait a day to actually get the download of the manual. Would have preferred to download it immediately after payment rather than waiting for someone to "process" my order. I was surprised that I had to wait that long.
;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
Check the insertion of part and replace of component part
2.
I2C Control Signal
SCL -Check Pont : R107 U201(155pin),U204(6pin), U401(41pin),U501(11pin) R452.
SDA -Check Point : R108 U201(156pin),U204(5pin), U401(40pin),U501(12pin) R451.
Failure Causes and
Solution � No Signal � message will be Display at TV Screen.
if Voltage is drop SCL as well as SDA. therefore each of part check
have to SCL with SDA of Voltage 3.2 ~3.5V. are replace of component Part, Check the
Check the install chip-position and short of solder, cold solder, etc. Where insertion of part
|
|
|
> |
|
