|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual is complete with excellent quality! One suggestion, show number of pages and weather it is multi-lingual. The AD 600 Manuel is about 76 pages and over half is non English. This results in a larger print job than usually needed. Having this information, one could select the desired pages for printing.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
Lift-Up Cooktop
1. Lift front of cooktop 2.
at corners and swing up the support rod. Carefully lower the cook-top onto the support rod.
3. Wipe surface under cooktop with warm soapy water. Use soapy plastic scrub pad on stubborn
Spots.
CAUTICN: Do not drop the oooktop. Damage can result to the poroelaln and the oooktop tmme.
Surface Burners
TWICAL TOP BURNER RIME
Lift up the cook-top, following the instructions above. Wipe off surface burners with warm soapy water and a soft cloth after each use. Occasionally check surface burner flames for size and shape as shown. If flames do not burn properly, you may need to remove the surface burners for cleaning (see pageM], or call a qualified technician for burner adjustments. To adJust the LO sefflngs on the control knobs: 1. Turn on the surface burners, then set the controls on LO. 2. Wlthout changing the burner rettlngs, remove the control knobs. 3. Firmly grasp the control stem and insert a small bladed screwdriver into the end of the stem. Turn the screwdriver in either direction until the flame height is Yein (.3l8 cm] or lower in size. Flame must be large enough to malntaln a STABLEFLAME on all burner ports. NEVERADJUST THE FLAME SIZE AT THE MEDIUM SElllNG.
|
|
|
> |
|
