|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
INSTALLATION OF THE SOFTWARE
2.0
Follow these steps to install the software: 1. Insert the JBLCOM disk into either drive A or drive B. 2. From the Windows Program Manager, click File from the menu bar and select Run. 3. In the Command Line text box type in a:setup, or b:setup depending upon in which drive you have placed the JBLCOM disk. 4. Click on the OK button. 5. Click on the Continue button to accept the default directory. A program group will be automatically created in the Program Manager. To run the software, click on the icon labeled JBLCOM. The �rst time the software is run, click Setup from the menu bar to specify the COM port you will be using to communicate with the STC-1. This COM port setting will be saved until the next time you change it.
2.1 Preparing the STC-1 for Communication
1. Plug the RJ-11 (telephone) plug into the STC-1�s communication port. 2. Make sure the other end of the cable is plugged into the DB-9 (9 pin) connector provided, and then plug the DB-9 into the correct COM port on your PC. If your COM port uses a DB-25 connector, use the 9-to-25 pin adapter provided. 3. Enter the Program Mode on the STC-1 and press the Computer Link button. As long as the STC-1 is in the computer link mode, the Computer Link button will be �reversed� and the unit will be ready to send or receive data. To exit this mode, simply touch any area of the STC-1�s screen. NOTE: The STC-1 CANNOT power-down automatically when in the computer link mode. If left in this mode for an extended period of time, the unit�s batteries will become completely discharged. For this reason it is recommended that when communications are performed to the STC-1, the STC-1 is running off of the AC adapter.
5
|
|
|
> |
|
