|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
STR-DA2ES/DB1080 SECTION 5 ELECTRICAL ADJUSTMENT
OSD ADJUSTMENT
Connection
frequency counter VIDEO board CN306 pin 1 or pin 2 + �
Procedure: 1. Short the CN306 pin 4 on the VIDEO board to the GND. 2. Connect a frequency counter to the CN306 pin 2 on the VIDEO board. 3. Press the I/1 button to turn on the main power. 4. Press the [CUSTOMIZE] button. 5. Press the [>] button to display �COLOR SYSTEM�. 6. Turn the JOG DIAL to display �NTSC�. 7. Press the [>] button to display �OSD H.POSITION�. 8. Adjust the CT302 so that the frequency counter reading is 3.57954 MHz. 9. Press the [<] button to display �COLOR SYSTEM�. 10. Turn the JOG DIAL to display �PAL�. 11. Press the [>] button to display �OSD H.POSITION�. 12. Adjust the CT301 so that the frequency counter reading is 4.43361 MHz. 13. Press the I/1 button to turn off the main power. 14. Connect a frequency counter to the CN306 pin 1 on the VIDEO board. 15. Press the I/1 button to turn on the main power. 16. Press the [CUSTOMIZE] button. 17. Press the [>] button to display �OSD V.POSITION�. 18. Adjust the CT303 so that the frequency counter reading is 7.20 MHz.
Note: The steps 5, 6 and 9 to 12 should be performed to the models except for the STR-DA2ES and STR-DB1080: Korean.
Adjustment and Connection Loacation: � VIDEO BOARD (Component Side) �
1 CN306 4
IC305
IC306
IC304
CT302 CT301 IC310 CT303
12
|
|
|
> |
|
