|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
 ;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
SECTION 4 TEST MODE
Fluorescent Indicator Tube Test Mode All fluorescent segments are tested. When this test is activated, all segments turn on at the same time, then each segment turns on one after another. Procedure: 1. While pressing two buttons of [TV/SAT] (US model)* and [DIRECT] simultaneously, press the 1/u button to turn the power ON. 2. All segments turn on at the same time, then each segment turns on one after another. 3. The message �FINISH� appears when this test is complete. *) AEP, UK models are [TV/LD] AUTO-BETICAL Check Mode (AEP, UK models) To auto-scanning and memories of RDS station. Procedure: 1. While pressing the [MEMORY/ENTER] button, press the 1/u button to turn the power ON. 2. The message �AUTO BET� appears and each function is selected one after another. AM Tuning Interval Selection Mode (US model) Either 9 kHz step or 10 kHz step can be selected for the AM tuning interval. Procedure: 1. Set the FUNCTION to AM. 2. Press the 1/u button to turn the power OFF. 3. While pressing the [TUNING+] button, press the 1/u button to turn the power ON. 4. Either the message �9k STEP� or �10k STEP� appears. 5. Select the desired step. Software Version Display Mode The software version is displayed. Procedure: 1. While pressing two the buttons of [MD/TAPE] and [DIRECT] simultaneously, press the 1/u button to turn the power ON. 2. The software version is displayed.
�7�
|
|
|
> |
|
