|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
material (top-quality metacrylate) may be drilled as easily as wood, as soon as you take care to use a slow speed drill. Otherwise warmth generated by the friction can damage the material.
8. PLATTER SET-UP Put the platter on the motor axis. The position is indifferent and adjustment of the leveling has been made at the factory. If you need to readjust the leveling after exchanging the motor, unscrew very carefully one of the top three bolts on the motor assembly until the platter rotates flatly. In case of difficulty, consult your nearest GOLDMUND dealer.
9. LEVELLING If the correct leveling of the wood box has been executed properly in the beginning of the set-up process, you may now perform the next step to adjust the sub-chassis horizontality. Otherwise you must now adjust the box level by action on the three black feet, using an external bubble level. To level the sub-chassis, insert in each of the three holes drilled above the suspension pods one 5mm allen key provided in the accessories. Turn each one until you reach the proper level of the sub-chassis and the horizontality of the bubble level. The proper level of the sub-chassis is reached when the top plate is approximately 5mm below the top level of the box sides.
10. DUST COVER ASSEMBLY Place the back of the dust cover in front of the hinges. Insert from the back of the hinges the supplied screws. On the cover side, insert one washer and one nut. Tighten the screws with the appropriate allen key.
11. CONTROL PANEL Plug the power supply in the turntable socket, located on the back panel. Put the table on by setting the left switch to the ON position. Speed selection is performed by setting of the second switch. The glowing 33 or 45 light indicate the platter speed. The LOCK indicator glows as soon as the precise speed (regulated by quartz) is reached.
12. CLEANING To clean the lacquered wood, you can use any of the very fine polish used for the old lacquered furniture. Always use a very soft cloth to avoid to scratch the surface.
|
|
|
> |
|
