|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
 ;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
;
Nice pdf file of the manual sent promptly. Thanks.
;
Complete MFG Service Manual at a good price FAST !
;
Downloaded the manual, reasonably straightforward, pretty much exactly as advertised.
SUB135S Cinema ProPack 600
SUB135S Test Set Up and Procedure
SYSTEM AURAL SWEEP TEST Equipment needed: � Function/signal generator/sweep generator � Integrated Amplifier � Multimeter General Unit Function (UUT = Unit Under Test) 1. From the signal generator (set initially at 0 volts), connect one line level (RCA) cable to the SUB135S LFE jack on the UUT. 2. Plug in the power cord; turn the power switch ON. LED should be Red. 3. Turn up the generator and adjust to 300mV, 40 Hz. LED should now be Green. 4. Immediate bass response should be heard and felt from port tube opening. Sweep Function 1. Follow steps 1-4 above, using a sweep generator as a signal source. 2. Sweep generator from 20Hz to 1kHz. Listen to the cabinet and drivers for any rattles, clicks, buzzes or any other noises. If any unusual noises are heard, remove woofer and test. Driver Function (Woofer) 1. Remove woofer from cabinet; detach the + and - wire clips. 2. Check DC resistance of woofer; it should be 3.4 ohms ±10%. 3. Connect a pair of speaker cables to driver terminals. Cables should be connected to an integrated amplifier fed by a signal generator. Turn on generator and adjust so that speaker level output is 5.0V. 5. Sweep generator from 20Hz to 1kHz. Listen to driver for any rubbing, buzzing, or other unusual noises. Caution: take care to replace the + and - wire clips on the correct terminals, as they are the same size. Red wire should connect to the red dot on the terminal.
5
|
|
|
> |
|
