|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
 ;
I received a good service manual, with good resolution. Improve the instructions for the purchase because they are not well understood.
For the rest, so good.
Thanks Angel.
;
Very good documentation for the Grundig 2077 model (as well as similar 800/900/1000 series radios). The first two pages are a summary of reception specifications and output capability. The third page is the tuner dial indicator and dial cord routing diagram. the final ~5 pages are the schematics for the various models (including 2077). The scan quality of the schematics are good, adn can be easily read if zoomed in. The documents are in German, not English as stated. It would have been nice to have the tuning sequence and settings, and some trouble shooting materials... or component and wiring map.
;
Perfect like it was descriped, Perfect like it was descriped
;
Very good detail, all pages clear, exactly what I needed
B. ADJUSTMENT OF THE A/C HEAD ASS'Y (TILT ADJUSTMENT)
a. Play back a T-120 Tape and check the running condition of the TAPE at the lower flanges of the T GUIDE POST ASS'Y ¤æin Fig. 5-1. b. Adjust the A/C HEAD TILT SCREW untill the TAPE runs stable as shown in Fig. 5-2
TURN THE A/C HEAD TILT SCREW TO THE DIRECTION OF CW
(
)
(
)
TURN THE A/C HEAD TILT SCREW TO THE DIRECTION OF CCW
Fig. 5-2 A/C HEAD ASS�Y ADJUSTMENT (TILT ADJUSTMENT)
C. ADJUSTMENT OF THE AUDIO AZIMUTH (See Fig.5-3)
a. Play back the ALIGNMENT CASSETTE TAPE (NTSC: DN2 (SP 7KHz), PAL: DP2 (SP 6KHz)) , , b. Observe audio signals on an OSCILLOSCOPE. c. Turn the A/C HEAD AZIMUTH SCREW to obtain the maximum audio output signal (-9~-3dBm).
Fig. 5-3 A/C HEAD ASS�Y
D. THE HEIGHT ADJUSTMENT OF A/C HEAD
a. Play back a T-120 TAPE. b. Make sure that the gap is 0.25mm between the lower end of TAPE and that of A/C HEAD. c. When the gap is longer than 0.25mm, turn the A/C HEAD HEIGHT ADJUST NUT counter-clockwise. When the gap is shorter than 0.25mm, turn it clockwise. Repeat this procedure untill 0.25mm is obtained.
GAP
Fig. 5-4 A/C HEAD ASS�Y ADJUSTMENT (HEIGHT ADJUSTMENT)
29
|
|
|
> |
|
