|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Assembly
Assembling the speaker stands requires use of a medium Phillips screwdriver.
Wall Mounting
� This speaker system is supplied with a mounting fixture for wall mounting. When using the speaker system in a wall installation, take full precautions to prevent the speaker from falling. � Check the wall location thoroughly to ascertain its ability to support the weight of the speaker system. � If you are unable to determine the structural strength of the wall, consult a building professional before attempting to install the speaker system on a wall. � No screws or bolts are provided for use in a wall installation. Supply your own threaded fasteners in accordance with the wall or pillar's material structure and strength. � Install only on a vertically plumb surface. Installation at an angle may result in dangerous loosening of the fixture, causing a fall. 1. First decide on whether you will install the speakers vertically or horizontally. Use commercially available threaded fasteners (screws or bolts) to attach the accessory mounting fixtures to the wall. When installing the speakers horizontally, use two screws installed at the two locations shown (left and right); when using a vertical installation, place one screw in the center as shown.
Wall hanging screws (buy commercially)
Connect speaker wires before assembly
Installation example 1 (Horizontal installation)
1. Affix mounting pads
Pads
2. Use two supplied screws to fasten the speaker stand to the speaker
Installation example 2 (Vertical installation)
1. Affix mounting pad
Pad
Horizontal installation
Vertical installation
2. Loosen the screws slightly to allow the mounting fixture to be removed. 2. Use 4 supplied screws to attach the accessory mounting fixture to the speaker stand (Fig. a) 3. Use 2 supplied screws to attach the mounting fixture and speaker stand to the speaker (Fig. b)
(Fig. a) (Fig. b)
3. Attach the speaker wire to the speaker. 4. Use one provided accessory screw and one washer to attach the accessory safety wire to the speaker as shown. 5. Use two provided accessory screws to attach the speaker to the mounting fixture. 6. Use a commercially available screw or bolt and one of the provided accessory washers to connect the loose end of the safety wire to the wall. 7. Align the speaker with the screws installed in step 1, and fasten to the wall.
English Español ä¸æ��
Installation Example 1 (Horizontal installation)
Safety wire Commercially purchased screw
Pay special attention to choosing a safe installation location when mounting the speaker vertically, since it may tend to tip over.
Accessory screws
Washers
3 En
|
|
|
> |
|
