|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
S-W80S
7. GENERAL INFORMATION
7.1 DISASSEMBLY
Removing the Amplifier Assy
1 ) The Amplifier Assy is attached to the cabinet by 4 external screw 1. To detach it, pull down the subwoofer toward the left side. Then unfasten those screws 1 (� 4) 3 ) The SW. Assy and LED ASSY is attached to the front panel by each 2 screws. To detach them, remove the Amplifier Assy first. Then unfasten each screws from the cabinet back side.
Be sure to bind the POWER SW lead and LED lead by the cable holder(twist-lock).
LED ASSY SW. ASSY
Screw1
2 ) Stand up the speaker again. After unfastening the rear panel screw 2 (� 8), pull straight the Amplifier Assy toward back about 13cm. Then remove the connecting cord of SW. Assy and LED Assy. Next, pull out the Amplifier Assy and remove the speaker cords.
2 2 2 2
Bind the SP lead by the binder.
Removing the Subwoofer
1 ) The speaker element is attached to the back board by 4 external screws 3 and washers. To detach it, unfasten those screws and washers. 2 ) When attaching the speaker, face its terminal downward. (Screws must be used with washers.)
LINE LEVEL
INPUT OUTPUT
SPEAKER LEVEL
R
L
OUTPUT
2
INPUT
2
+ -+
3
3
2
2
Rear Panel
3
Bind the Power SW lead Amplifier Assy and LED lead by the binder.
3
Be sure to fix the lead between CNTL-ASSY and POWER ASSY to the chassis by the binder.
50
Hz
200
LINE LEVEL
INPUT OUTPUT
SPEAKER LEVEL
R
L
OUTPUT
INPUT
+
-
-+
Removing the Front Panel
The front panel is attached to the baffle by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side.
Be sure to bind the secondary side lead of the transformer by the binder.
17
|
|
|
> |
|
