|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very complete and well reading drawings. Documentation is essential for successful repairs.Good documentation, with all that is necessary. This manual was what I was waiting with all the information necessary for the repairing I need it for. You must buy it if you want to do repairs or simply understand how it works.
 ;
Excellent service manual includes everything is need to repair this radio-caseete, how to disassemble, wiring diagram, all , waiting time until the download was only a few hours. I'm going to buy service manuals from here, are cheap and very good.Thank you.
 ;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
 ;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
CX-LEM200
ADJUSTMENTS BEFORE OPERATION
POWER 6STANDBY/ON ECO ECD, TUNER/ BAND, cTAPE, AUX f,g POWER CLOCK ENTER f,g
Setting the clock
1 In stop mode, hold down SHIFT and press CLOCK on the remote.
Go to step 3 when the hour of the clock display flashes.
2 Within 6 seconds, press ENTER.
The hour flashes in the display.
ECD, TUNER/ BAND, dTAPE, AUX SHIFT DIMMER
3 Press f or g to set the hour, then press ENTER. 4 Press f or g to set the minute.
Each press changes the time in 1-minute steps.
En
5 Press ENTER.
The time display stops flashing and the clock starts from 00 seconds. To display the time while the power is on Hold down SHIFT and press CLOCK on the remote. The time will be displayed for 6 seconds. If "- -:- -" appears when the unit is turned off There has been a power interruption. Reset the clock.
Power
Turning the unit on Press POWER 6STANDBY/ON (POWER on the remote ). Alternatively, press cTAPE, TUNER/BAND, AUX or ECD. Playback will start automatically if a disc or tape is loaded. Turning the unit off Press POWER 6STANDBY/ON again. The unit goes into standby.
ECO mode
Reduces power consumption in standby mode with the following operations.
Press ECO. Each press of the button changes the mode as follows;
ECO ON: Power economizing mode is activated. When the unit turns off, everything in the display disappears and only the red indicator above POWER lights to show that the power is being supplied. ECO OFF: Power economizing mode is cancelled. When the unit turns off, the clock display appears. Initial mode is ECO OFF. Standby power consumption ECO ON: 0.3 W ECO OFF: 6 W
Dimmer
The display window brightness can be selected.
Press DIMMER on the remote repeatedly. Each press of the button changes the following three levels: "DIMMER 1", "DIMMER 2" and "DIMMER 0". "DIMMER 0" is the brightest.
7
6
|
|
 |
> |
|