|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Assembly
Assembling the satellite speakers
Each speaker (except the center speaker) has been divided into three parts for shipment. Before using this speaker system, assemble it first by following the procedure below.
English
2 Join the leg to the stand.
� Rotate either the leg or stand so that the mark on the leg and the mark on the stand are facing the same direction. � Make sure to match the screw holes on the leg with those on the stand so that they are aligned correctly.
mark Leg
Speaker section
Leg
Stand
Stand
� Prepare a Phillips screw driver. Before assembling� � Take care not to drop the stand while assembling; otherwise, it may cause damage to the floor or injury. � Ensure enough space for assembly and installation. � Place a large, thick cloth on the floor where you assemble the speaker, so you can protect the floor and the speaker itself. � Use the speaker only after assembly is fully and correctly done.
mark
3 Fix the leg to the stand with three of the
supplied screws�long: M4 x 25 mm (M4 x 1 in.).
Leg
Attaching the leg and the stand
1 Remove the terminal cover from the leg.
First remove the screw on the terminal cover, then detach the cover by pulling it upward. � You will need to use the removed screw in step 5 on page 4.
Terminal cover
Stand
Screw
Screw
� Do not tighten each screw completely as you put them in place. First put all screws in, then tighten them evenly and firmly.
claws grooves
Leg
It is recommended to place a cushion under the leg. � You can tighten the screws easily by placing the leg horizontally.
Cushion
�3�
|
|
|
> |
|
