|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
Problem solving guide
What to do if, . . . ?
. . . the drum door opens during the drying cycle?
Cause . . .
The machine has overheated. The temperature limiter opened the drum door and caused the machine to turn off automatically. Possible reasons for overheating: � The lint filter in the door is clogged. � The vent duct is blocked. � The vent aperture (e.g. louvred window vent, wall vent) is blocked. This may not be a problem. A dual filter system with two seals is used to prevent lint from becoming deposited in the heat exchanger.
Remedy . . .
Before restarting the program, proceed as follows: � Release the ON/OFF button. � Clean the affected part of the machine. � Turn on the machine again. � Reselect the terminated program. � Press the �Start� button. If the drum door opens again, the Miele Service Dept. should be contacted. These two seals may occasionally cause condensed water to form on the door. Laundry coming into contact with these drops of water will dry within in a few minutes. Check that the heat exchanger door has been replaced correctly. If necessary, remove and replace it. See next page. See next page.
. . . drops of the water appear along the upper edge of the drum door?
. . . after cleaning the heat exchanger, water leaks from the machine? . . . the interior drum light fails to function? . . . you have to open the door in the event of a power failure?
19
|
|
|
> |
|
