|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great quality copy, right what I was looking for, all I need to fix my radio.
Thanks
;
I BOUGHT A PAIR OF INFINITY VINTAGE SPEAKERS THAT REQUIRED TO BE REPAIRED AND THE ELECTRONIC TECHNICIAN ASKED ME FOR THE SERVICE MANUAL.
I TRIED TO GET IT AT THE MANUFACTURER'S SITE WITH NO SUCCESS, SO I STARTED TO LOOK FOR IT IN THE WEB FOR A LONG TIME, UNTIL I FOUND THE SERVICE MANUAL IN THIS EXCELLENT SITE "OWNER'S MANUAL.COM".
NOW I HAVE MY SPEAKERS WORKING AND ENJOYING THE MUSIC I LIKE.
THANKS TO "OWNER`S MANUAL.COM" I RECOMMEND THIS SITE TO EVERYONE.
;
Very quick response. Very good and accurate print quality of the scanned document.
 ;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
;
Excellent manual. Helped me out with disassembling and troubleshooting my projector.
SECTION 1 SERVICE NOTE
ALL CLEAR Mode which erases all the user memories registered in this unit and sets to setting at shipment. Method: 1. With the power turned OFF, press the POWER button while pressing the TAPE MONITOR button and VIDEO 2 button simultaneously to turn ON the power. 2. ALL CLEAR ! will be displayed on the fluorescent indicator tube, and ALL CLEAR will be executed. FACTORY SET Mode which sets the memory of the unit to the setting of adjustment and check at factory. (Not used for servicing.) Method: 1. With the power turned OFF, press the POWER button while pressing the SPEAKER button and TAPE button simultaneously to turn ON the power. 2. FACTORY SET will be displayed on the fluorescent indicator tube, and FACTORY SET will be executed. Note: In case you return the unit to the customer, do not perform FACTRY SET. If you do it, perform ALL CLEAR. Fluorescent indicator tube, LED all lit mode and key check mode Method: 1. With the power turned OFF, press the POWER button while pressing the TAPE MONITOR button, VIDEO 1 button, and VIDEO 2 button simultaneously to turn ON the power. 2. The fluorescent display tubes and LEDs will all light up. 3. The display will change as follows each time buttons other than GENRE and MODE are pressed. Therefore, it can be checked if buttons have been input properly by whether the display changes. N Adjustment of OSD Screen Position The position of the screen can be adjusted freely to correct the deviation of the OSD screen caused by the monitor type that users are using. 1. Move the cursor of the remote commander attached, and display the OSD screen. 2. Click the MAIN MENU FUNCTION of the OSD screen. 3. Next click TV SET. 4. Next click GRAPHIC POSITION SET. 5. The screen for adjusting the OSD screen position will be displayed. Adjust the position with the remote commander attached. 6. Click EXIT to end.
Fluorescent indicator tubes, LEDs are all lit N Press any button
Partial lighting of fluorescent indicator tube 1, LEDs are OFF *1 N Press any button
Partial lighting of fluorescent indicator tube 2, LEDs are OFF *1 N Press any button
Fluorescent indicator tube and all LEDs are OFF *1 N Press any button
*1 Those other than the POWER LED go OFF. 4. To exit the mode, press the POWER button to turn OFF the power.
�3�
|
|
|
> |
|
