|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
 ;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
 ;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
 ;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
Removing and replacing the 40 mm lamp fan and lamp blower
The 40 mm lamp fan (Both: 526-0035-xx) and lamp blower (Both: 526-0036-xx) fasten to the side of the lamp housing. The two fans work together to cool the lamp module inside the lamp housing. Both fans are included with a new lamp housing or with a new optical engine. Both are also available separately. Blower ducting
Lamp blower
40 mm lamp fan 1 2 3 Remove the chassis and attached parts from the top case (see page 96). Remove the lamp housing (see page 100) Do one of the following: a To replace the 40 mm lamp fan, remove the two M3x12 pan head Phillips screws that fasten the lamp to lamp housing.
TDP-B1&B3 Service Resource Guide
106
|
|
 |
> |
|