|
There are currently no product reviews.
 ;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
Remove and replace the focus and zoom rings
The focus ring (505-0972-xx) fits around the front of the projection lens. The zoom ring (505-00974-xx) fits behind the focus ring. The lens cap (505-0841-xx) snaps onto the focus ring. Both the focus ring and the zoom ring snap into place. They can be replaced without removing the front bezel or top case. 1 2 Stand the projector lens side up on the work space. Grasp the focus ring and pull it off of the lens barrel.
3
Grasp the zoom ring and pull it off of the lens barrel.
Assembly Notes
� � Both rings have three slots or tabs that align with pins or slots on the lens barrel. Align the tabs on the zoom ring with the three slots on the lens barrel, and then press it into place. It should fit close to the front bezel, but should not touch the bezel.
TDP-S3/TDP-T3/TDP-MT5 Service Manual
11
|
