This place is amazing. Got our manual in a few hours. Print quality is excellent. Even the manufacturer didn't have this manual. The price was excellent. How many more stars can I give them? More than satisfied.
This was a very hard to find manual. The unit is long discontinued and Pioneer doesn't retain every manual for every model. Thanks owner's-manual.com!
Text excerpt from page 42 (click to view)
6 Lift and grasp the pull tab and lift the module out (Figure 23). Dispose of the lamp module in an environmentally proper manner.
pull tab
FIGURE 23 Removing the lamp module
7 Install the new lamp module, being sure to align the connectors properly. 8 Push the module in until it is flush with the bottom case of the projector. 9 Tighten the screws on the outside of the module. 10 Replace the lamp door by inserting the hooks on the lamp door into the slots on the projector and pressing the lamp door into place. If the lamp door does not fit properly or bulges out, remove the door and re-seat the lamp module. 11 Plug in the power cord and press the Power button to turn the projector back on. 12 To reset the lamp hour counter in the Status window, press and hold the volume - button, then press the menu button (while still holding down the volume - button) for 5 seconds. Verify that the counter was reset by pressing the menu button and viewing the counter in the Status window.
WARNING: Do not drop the lamp module or touch the glass bulb! The glass may shatter and cause injury.
