|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Product was very good. Received quickly and complete
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Using
the automatic
cycles
(on some mudds)
Your automatic control senses the dryness of the load and automatically shuts off when the selected dryness is reached. For the first few loads: 1. Set the cycle Control Knob to point to the center dot in your automatic cycle. 2. Select a heat setting to match your load. 3. Feel the dried items when the dryer stops. if the items are d&w than you like, select a setting closer to LESS DRY the next time you dry a similar load. it items are not as dry as you like, select a setting closer to VERY DRY the next time you dry a similar load. The Cycle Control Knob will not move until the load is almost dry or the cool-down portion of the cycle has been reached. After the cool down is complete, the Cycle Control Knob automatically moves to an OFF area and the tumbling stops. NOTE: Your model will not look exactly like the illustration.
Using
the air cycle
(no heat)
Fire Hazard Do not dry plastic or rubber items with heat. Use the air cycle, or line dry. Failure to do so could result in fire or damaged items. The dryer does not heat when the Cycle Control Knob is set in the air cycle. This cycle can be used to fluff or air dry bedding, plastic tablecloths, foam pillows, sneakers, etc. 1. Turn the Cycle Control Knob to the number of minutes you want in the air cycle. Refer to the chart below for suggested times. 2. Push the Start Button. NOTE: Repeat steps above if more time is needed to dry items. TYPE OF LOAD RUBBER, PLASTIC, HEAT-SENSiTiVE FABRICS Foam Rubber-Pillows, bras, stuffed toys PlastioShower curtains, tablecloths Rubber-backed rugs Olefin, Polypropylene, Sheer nylon 8 I CYCLE AND TIME Air 20-30 min 20-30 min 40-50 min 15-20 min
|
|
|
> |
|
