|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Caring For Your Dryer
I
In This
Section
Paga
Maintenance-as
Paw
needed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 I
Maintenance-wary
load . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . .. 12
Dryers require regular maintenance. Follow the suggestions below to maintain your dryer properly.
Maintenance-every
Cleaning the lint screen
load
Product and Fabrk Damage Hazard Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics.
The lint screen is located under a lid on top of the dryer. Clean tt before each load. A screen blocked by lint can increase drying time.
1. Open the lid and pull the lint screen straight out.
2. Roll lint off the screen with your fingers. Do not rinse or wash the screen to remove lint. Wet lint is hard to remove. 3. Push the lint screen firmly back into place and close the lid.
Lint
signal
(on some models)
Restricted airflow reduces drying efficiency. The signal (a whistle tone) lets you know if the airflow is restricted. l Turn off the dryer and clean the lint screen. NOTE: Clean your lint screen before each load. Do not wait for the lint signal. The lint signal indicates excessive lint present on your lint screen. If you wait for the lint signal before you clean the lint screen, drying efficiency will be reduced.
12
|
|
|
> |
|
