|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
;
Another excellent buy! File too clear and explanatory.
 ;
A manual hard to find. It was very helpful to restore my device.
;
I am very grateful for this manual. Without it could not repair my receiver.
;
excellent work as always you do cheap, fast net and clean. you do an incredible service......thanks!
Name of measuring instrument RF generator Base Band generator Adjustment of AV system
Connection
Remarks
Remarks
1. Receive AV1 (PAL-M or NTSC 100% Full White or Split Colour bar shown as below).
2. Goes into service mode, choose Sub-Contrast, and it checks that data value is 512. (It checks that an initial value is a default) 3. The colour key yellow button of remote control is pushed. 4. The OSD character of sub-contrast becomes red. (Inside under automatic adjustment) 5. The OSD character of sub-contrast returns to white. 6. End.
Adjustment of RF system
1. Receive a RF. (PAL-M or NTSC 100% Full White or Split Colour bar shown as below).
Remarks
2. Goes into service mode, choose Sub-Contrast, and it checks that data value is 512. (It checks that an initial value is a default) 3. The colour key yellow button of remote control is pushed. 4. The OSD character of sub-contrast becomes red. (Inside under automatic adjustment) 5. The OSD character of sub-contrast returns to white. 6. End.
Adjustment of HD system
1. Recieve Component (1080i/ 60Hz or 1080i/ 50Hz, 100% Full White or Split colour bar as shown below).
Remarks
2. Goes into service mode, choose Sub-Contrast, and it checks that data value is 384. (It checks that an initial value is a default) 3. The colour key yellow button of remote control is pushed. 4. The OSD character of sub-contrast becomes red. (Inside under automatic adjustment) 5. The OSD character of sub-contrast returns to white. 6. End.
4. Conductor Views
4.1. TU-Board 4.2. DG-Board
5. Schematic and Block Diagram
5.1. Schematic Diagram Note
12
|
|
|
> |
|
