|
Who's Online
There currently are 5659 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
TH-37PD25U-P / TH-42PD25U-P
b. Remove coupler (CC24) connected to the C2 board. c. Remove C2 board fastening screws (�4), and remove the C2 board.
17. Remove the front frame. a. Leaving the front glass and front board unit attached to the front frame, pull the bottom of the front frame forward, lift, and remove.
15. Remove the shield plate (bottom). a. Remove the shield plate (bottom) fastening screws (�7), and remove the shield plate (bottom).
16. Remove the rear cover mounting brackets. a. Remove the rear cover mounting bracket (top) fastening screws (�4), and remove the rear cover mounting bracket (top). b. Remove the rear cover mounting bracket (left, right) fastening screws (�4 each), and remove the rear cover mounting brackets (left and right). 18. Remove stand brackets. a. Remove the plasma panel section from the servicing stand and lay on a surface such as a table (covered), with the plasma panel surface facing downward. Spread a soft cloth or similar on the table for protection, so the panel surface is not scratched. b. Remove the stand bracket (left, right) fastening screws (�4 each) and remove the stand brackets (left, right).
c. Remove the fastening screws (�2) holding the front frame and plasma panel.
12
|
|
|
> |
|