|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I liked the product. I would use their sevices again.
 ;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
9. Remove the screws (�2 ). 10. Disconnect the couplers (K1). 11. Remove the K-board.
6.28. Replace the plasma panel (finished) 1. Place the new plasma panel (finished) on the flat surface of the table (covered by a soft cloth), with the plasma panel surface facing downward. 2. Attach the C1-Board and the C2-Board, connect the flexible cables (�8) from the Plasma panel to the C1-Board and the C2-Board, and fit the flexible cable holders. 3. Attach the Hooks (left, right) and fit the stand brackets (L, R) to the new plasma panel. 4. Place the plasma panel section on the servicing stand. 5. Attach the front frame and each P.C.Board and so on, to the new plasma panel. * When fitting the front frame, be careful to allow any debris, dust or handling residue to remain between the front glass and plasma panel.
24
|
|
|
> |
|
