Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
Text excerpt from page 13 (click to view)
Insert the ducting spigot into the aperture on the top of the cooker hood casing.
Fitting the Wall Cabinet
If it is necessary to fix the kitchen cabinet to a hollow construction plaster or partition board structure then it must be sufficiently reinforced to be strong enough to support the weight of the cooker hood.
Wall Cabinet Preparation
Position the cooker hood upside down, ensuring the cooker hood is supported. Open the visor and remove the two metal grease filter cassettes (see maintenance and cleaning section). Mark the position for the cut-out for the cooker hood on the underside of the kitchen cabinet. The cut-out should measure, lenght 503 mm by depth 162 mm. Mark the position for the cut-out for the ducting on the top of the kitchen cabinet ensuring that the centre of the hole aligns with the centre of the ducting spigot. A pad saw or similar cutter will be required to cut the rectangular hole for the cooker hood and the circular hole for the ducting spigot. Before inserting the cooker hood inside the cabinet ensure a hole has been provided to route the mains cable.
KSecuring the cooker hood to the wall
cabinet
1. Insert the upper casing of the cooker hood through the hole from the underside of the cabinet ensuring that the butterfly bracket screws have been loosened sufficiently to allow the wings to be folded back. Tighten the butterfly bracket screws, by rotating the screws clockwise. If further alignment of the cooker hood is required the lower section of the casing can be adjusted horizontally, backwards and forwards.
