|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I do not have very much to say.
The price is quite covenient, delivery was better as promised (about 12 ours, against the specified 24 hours if I remember well), and the quality of the PDF is more than acceptable.
The Service Manual of Sansui R30 itself is also satisfactory: good graphic for schematics and layouts, simple and well structured.
Giovanni Bianchi
;
Happy to find finally a schematic for this amplifier. The schematic is of good quality, the pcb layout is useless: all is black. Never the less, it is very easy to find the components on the board using the schematics.
;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
TH-50PX600U
6.29. Remove the S-Board
1. Disconnect the coupler (S1). 2. Remove the screws (�2 frame. 3. Remove the screws (�2 ) and remove the S-Board metal ) and remove the S-Board.
6.31. Remove the Plasma panel section from the Front frame (glass)
1. Remove the front frame and the plasma panel fastening screws (�12 ). 2. Remove the front frame and the stand brackets fastening screws (�2 ).
6.30. Remove the GS-Board
1. Remove the stand bracket R. (See section 6.23.) 2. Unlock the cable clampers to free the cable. 3. Disconnect the coupler (G52). 4. Remove the screws (�3 5. Remove the SD card unit. ). 3. For leaving the plasma panel from the front frame, pull the bottom of the front frame forward, lift, and remove.
6. Remove the screws (�2 cover. 7. Remove the GS-Board.
) and remove the GS-Board
18
|
|
|
> |
|
