JVC TH-A5
Owner's Manual

Creating Realistic Sound Fields

Adjusting DSP Sound Parameters
REW VCR CHANNEL TUNING B.SEARCH F.SEARCH FF

You can fine-adjust DSP modes more minutely by changing three parameters�room, liveness, and reverberation. Before you start, remember... � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

23
ENTER

1
VOLUME DVD FM/AM AUX MUTING

DSP MODE

Press DSP MODE (or DSP on the front panel) repeatedly to select the desired DSP mode.
SOUND

SOUND

1 4 7
SLOW

2 5 8 0

3
SETTING

2
DSP MODE

Press SOUND repeatedly to select the desired DSP sound parameter.
� Each time you press the button, the indication on the display changes as follows:

SOUND

6
PRO LOGIC

9
SETUP TEST

ANGLE

ZOOM

D.R.C

DSP MODE

REPEAT

A-B REPEAT PROGRAM

EFFECT

EFFECT

00 F 00 Normal indication (canceled)

00 R 00 REVERB LIVE

REAR ROOM

CLEAR

SEARCH

REMAIN

SLEEP

4

To adjust the output level for the rear speakers 1) Press SOUND repeatedly until �REAR� SOUND appears on the display.
� Each time you press the button, the indication on the display changes as follows:

ROOM : To adjust the resonance based on the room size. The larger this value is, the more effective the resonance is (from 04 to 16 by 2 steps). LIVE (Liveness) : To adjust the liveness. The larger this value is, the more liveness is obtained (from 04 to 16 by 2 steps). REVERB (Reverberation) : To adjust the reverberation time of the sound (from 0.0 msec to 1.6 msec by 0.2 msec steps). � The following diagram shows the �DEFAULT (initial)� settings of the DSP sound parameters for each DSP mode. DSP MODE HALL THEATER PAVILION DANCE CLUB LIVE CLUB ROOM 08 04 08 04 08 LIVE 16 10 04 08 16 REVERB 0.4 1.0 0.2 1.6 1.4

00 F 00 Normal indication (canceled)

00 R 00 REVERB LIVE

REAR ROOM

REAR : To adjust the output level for rear speakers (from �06 dB to +06 dB). � �REAR �06dB� is the initial setting. If you have already changed the setting, another value will appear.

2) Press 3 or 2 to adjust the output level.
3 : Increases the output level. 2 : Decreases the output level.

5

To adjust the overall level of DSP effect

EFFECT

3 4

Press 3 or 2 to adjust the DSP sound parameter.
3 : Increases the value. 2 : Decreases the value.

Press EFFECT repeatedly to adjust the overall level. �EFFECT (with the current setting)� or �DEFAULT� appears on the display. � Each time you press the button, the effect level changes as follows:

Repeat 2 and 3 for setting the other DSP sound parameters.

EFFECT 1 DEFAULT

EFFECT 2
Note:

EFFECT 3

Pressing EFFECT to adjust overall level of DSP effect will change your fine-adjustments to the fixed level.

As the number increases, DSP effect becomes stronger. � �DEFAULT� is the initial setting. For in-depth information about �DEFAULT (initial)� setting, see the table to the right.

24