|
Who's Online
There currently are 5573 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
POWER SUPPLY
Whenever convenient, use the power supply if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries. BATTERIES (NOT INCLUDED) 1. Open the battery compartment and insert six batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "-" symbols inside the compartment. Remote control (supplied) Open the battery compartment and insert two batteries, type AAA, R03 or UM4 (preferably alkaline). 2. Replace the compartment door, making sure the batteries are firmly and correctly in place. The set is now ready to operate. � If BATT LOW lights up, battery power is running low. � The BATT LOW indicator eventually goes out if the batteries are too weak. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore: � Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set. � When inserting new batteries, do not try to mix old batteries with the new ones. � Remove the batteries if the set is not to be used for a long time. Batteries contain chemical substances, so they should be disposed of properly. The type plate is located on the bottom of the set. Using AC POWER 1. Check if the power voltage as shown on the type plate on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2. If your set is equipped with a voltage selector, adjust the selector so that it matches with the local power supply. 3. Connect the power cord to the wall outlet and the set is now ready for use. 4. To disconnect the set from the power supply completely, remove the plug from the wall outlet. Standby power consumption . . . . . . . . . . . . . . . . . . . . . . . .3 W
6 x R20 � UM-1 � D-CELLS
9
English
|
|
|
> |
|