JVC TH-C9US
Owner's Manual

Connections

Do not connect the power cord until all other connections have been made.

This page is for TH-C9

Before connecting the speaker cords; Twist and pull the insulation coat off and remove.

Powered subwoofer TH-C9: SP-PWC9

Speaker cord (supplied)

� Connect the black cords to the black (r) terminals. � Connect the white cords to the (q) terminals referring to the table below:
FRONT SPEAKERS (LEFT) FRONT SPEAKERS (RIGHT) CENTER SPEAKER SURROUND SPEAKERS (LEFT) SURROUND SPEAKERS (RIGHT) White Red Green Blue Gray

Front speakers TH-C9: SP-THC9F

4m

10 m

Surround speakers TH-C9: SP-THC9S

4m Center speaker TH-C9: SP-THC9C

CAUTION
� When you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer. � DO NOT connect more than one speaker to one speaker terminal.

Precautions for daily use � When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury. � Do not reproduce sounds at so high a volume that they are distorted; otherwise, the speakers may be damaged by internal heat buildup. � When holding a speaker, always grasp the lower portion. � Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.

11