|
Who's Online
There currently are 5368 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Once again owner-manual.com has saved the day for me, and come through with the manual I need. I looked other places too, and couldn't find it anywhere. Thank You owner-manual.com!!! You're the BEST!
;
very good quality that can be magnified several times, and it remains readable.
For sure I will return next time the need for a service manual arise.
;
The service manual is really great - thanks to it I was able to install the laser unit and thus "save" my CD-player, which seemed to be impossible before I had the manual.
;
Downloaded the Service manual OK of the Technics Piano and have now repaired it and its going fine. Excellant; thank you for the fine servce. A.M
;
This site is working fine! Did buy a manual for SX-EX25L and after a while I could download it and fix the problem. Nice and easy!
4.6
Display of current value of laser
(1) Set the main body at test mode. (2) Press "CHOICE" key of the remote controller three times. Then, FL display is displayed "CHECK". (3) The laser current value can be switched between the value of CD and that of DVD by pressing the following key of the remote controller.
FL Display (Example)
1419 0000
Remote controller "4" key --- Laser of CD Remote controller "5" key --- Laser of DVD
� The number shown in the FL display shows mA of current value of laser. � The first two numbers ("14" in "1419") shows current value of laser at the time of adjustment after the latest all-initialization, 14mA in this example. � The last two numbers ("19" in "1419") shows the present current value of laser, 19mA in this example. � The first two numbers ("14" in "1419") usually shows current value of laser at the time of shipment, so you can see how the product has been deteriorated by comparing the first two numbers ("14" in "1419") and the last two numbers ("19" in "1419"). CD and DVD: The laser current value of 80mA or less in normal. The laser current value of over 81mA is not normal. Laser diode of the pickup has been deteriorated. � To return to test mode, press "STOP" key of the main body. 4.7 Flap adjustment of the pick-up guide shaft
Please perform flap adjustment of the pick-up guide shaft in the following case: � Just after you exchange the pick-up. � Just after you exchange the spindle motor. � Just after you exchange the traverse mechanism base. NOTE: Please perform flap adjustment of the pick-up guide shaft when you exchange the parts above and also when you remove the parts above. � When the reading accuracy of the signal is bad (There is a block noise in the screen, Screen stops in the outer circumference of a disc, etc.)
PLAY key (for jitter value) 4 key (laser of CD) 5 key (laser of DVD) STOP key (for test mode)
CHOICE key (switch of mode)
6 key (display of jitter value)
STANDBY/ON key
FL display
OPEN/CLOSE key (for test mode)
1-36 (No.MB075)
$4.99 TH-M55 JVC Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|