|
Who's Online
There currently are 5696 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
3. Main PCB Removal.
1) Remove the connector !0 (N901) of the degauss coil. 2) Remove the DY connector !1 and !2. 3) Remove the anode cap. 4) Remove two ground connector !3. 5) Move the CRT face down and remove two screws !4 securing the bottom fitting metal. 6) Remove the fitting metal and the PCB from the cabinet. 7) Remove five screws !5 securing the fitting metal and PCB. 8) Remove the PCB !6 with the figure referenced.
!5 !5
!5 !6
!4 !3 !3
!4
!1 !2
!0 N901
WARNING
The following label is stuck to the CRT GND Cable: In particular, when energizing the MAIN PCB by taking it fr om the Bottom Cabnet, it is necessar y to connect the GND Cable, without fail, to the ear th terminal of AC INLET for the prevention of electric shocks.
WARNING
When removing this CRT GND cable, Connect it to GND terminal of the AC inlet to prevent electric shock.
� 15 �
|
|
|
> |
|