|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
TK-190
REALIGNMENT
4-3. Programming
1. Set the transceiver to Main Programming Mode. (Refer to page 10) 2. Connect the KPG-36 to the transceiver. 3. Start up the programming software (KPG-59D), select "firmware program" in the "Program" item, and press the Return key on the personal computer. This starts up the firmware programmer. 4. The top screen is displayed. Press any key to advance to the next screen. 5. Set the communications speed (normally, 115,200bps) and communications port in the Setup item. 6. Set the firmware to be updated by File select. 7. Held down the [Side 2] and [PTT]. Turn the transceiver power on, and release [Side 2] first. Until the display change to "P R O G� R � A � M � " 8. Check the connection between the transceiver and the personal computer, and make sure that the transceiver is in the Main Program Mode. 9. Press F10 on the personal computer. A window opens on the display to indicate progress of writing. When the transceiver starts to receive data, "PG" is appeared on 2 digit sub display. 10.If writing ends successfully, the red LED on the transceiver lights and the checksum is displayed. 11.If you want to continue programming other transceivers, repeat steps 5 to 8.
Notes :
� To start the Firmware Programmer from KPG-59D, the Fpro path must be set up by KPG-59D setup. � This mode cannot be entered if the Main Program mode is set to Disable in the Programming software (KPG-59D).
4-4. Function
1. If you press the [Top 2] key while "PROGRAM" is displayed, the checksum is displayed. If you press the [Top 1] key while the checksum is displayed, "PROGRAM" is redisplayed. 2. A transmission speed can be selected by pressing the [Top 1] key while "PROGRAM" is displaed. 19200bps : P R O G R A M� 1dot lights 38400bps : P R O G R A�M� 2dots light 57600bps : P R O G R�A�M� 3dots light 115200bps : P R O G�R�A�M� 4dots light
Note :
Normally, write in the high-speed mode.
5. Panel Test Mode
Setting method refer to ADJUSTMENT.
11
|
|
|
> |
|
