|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
 ;
I liked the product. I would use their sevices again.
TK-2180
DISASSEMBLY FOR REPAIR
2. How to Stick the Sheet (G11-4326-04)
1) Remove the white separation paper of the sheet first (q) and stick the sheet on the front-glass (w). Next, remove the transparent separation paper of the sheet (e).
Sheet (G11-4326-04) e
4. How to Attach the VGS-1
1) Remove the 2 screws. 2) The tip of tweezers is put into the screw hole of the cover and is pried, the cover will remove. 3) Use the 2 rubber cushions and attach them to the VGS-1. 4) Plug the VGS-1 into the VGS-1 connector of the PC board, pressing down on the top of the VGS-1 until secure. 5) The spacer turns the adhesive surface down. Next, push between the chassis and VGS-1. 6) Replace the cover and tighten the 2 screws.
q
Front-glass w
3. How to Attach the TX-RX Unit
1) In order to attach the TX-RX unit in chassis, don�t put in the TX-RX unit aslant. Please level the chassis and the TX-RX unit and attach them.
Rubber cushion (G13-1995-04) 20 x 30 x 1.0 mm
VGS-1
Rubber cushion (G13-1974-04) 21 x 21 x 2.5 mm
VGS-1 VGS-1 connector Spacer (J30-1292-04) 4.5 x 24 x 3.0 mm
6
|
|
|
> |
|
