|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service manual helped me to repair my PIONEER. Iam very satisfied, that I found it here.
Even the price of manual was not so high that person would not be able to spend a few money.
But that is very worth spent money. Thanks
 ;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
TK-790/(B)/H(B)
DISASSEMBLY FOR REPAIR (TK-790H(B))
1. Removing the Case and Shield Cover
1. Remove the 12 screws ( 1 ), and remove the upper and lower halves of the case. (Remove the 6 screws holding the upper half and the 6 screws holding the lower half.) 2. Remove the 2 screws ( 2 ), and remove the shield cover.
3. Removing the Final Unit (X45-356)
1. Remove the 2 hexagonal bosses ( 5 ). 2. Remove the 3 screws ( 6 ) holding the power module and transistor to the frame. 3. Desolder the power module. 4. Remove the 1 screw ( 7 ) holding TH1. 5. Remove the 4 screws ( 7 ) holding the final transistor. 6. Remove the 2 screws ( 8 ) holding the lead terminal from DC connector (4P) on the rear. 7. Remove the 13 screws ( 9 ) holding the PC board. 8. Desolder W3 on the antenna connector.
2. Removing the TX-RX Unit (X57-561 A/3)
1. Remove the 7 screws ( 3 ), and remove the PLL shield case. 2. Remove the connector (CN201) and coaxial plugs (CN104, CN203) from the final unit, and remove the flat cable (CN202) upwards from the control unit (CN502). 3. Remove the 5 screws ( 4 ).
1 1 1 1
1
2
8 9 9 6 9 7 9 6 6 CN203 3 3 3 3 4 4 3 CN104 CN201 9 Final unit 9 5 9 9 9
8
3 3 4
44 TX-RX unit
Control unit
1 1 1 1
23
|
|
|
> |
|
