|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual was a good representation of service infomation for the EWV404. It worked well for my repair.
 ;
Great quality copy, right what I was looking for, all I need to fix my radio.
Thanks
 ;
I BOUGHT A PAIR OF INFINITY VINTAGE SPEAKERS THAT REQUIRED TO BE REPAIRED AND THE ELECTRONIC TECHNICIAN ASKED ME FOR THE SERVICE MANUAL.
I TRIED TO GET IT AT THE MANUFACTURER'S SITE WITH NO SUCCESS, SO I STARTED TO LOOK FOR IT IN THE WEB FOR A LONG TIME, UNTIL I FOUND THE SERVICE MANUAL IN THIS EXCELLENT SITE "OWNER'S MANUAL.COM".
NOW I HAVE MY SPEAKERS WORKING AND ENJOYING THE MUSIC I LIKE.
THANKS TO "OWNER`S MANUAL.COM" I RECOMMEND THIS SITE TO EVERYONE.
 ;
Very quick response. Very good and accurate print quality of the scanned document.
 ;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
TK-868G
INSTALLATION /
PA/HA Unit (KAP-1 : Option) Installing the KAP-1 in the Transceiver
The Horn Alert (max. 2A drive) and Public Address functions are enabled by inserting the KAP-1 W1 (3P; white/black/ red) into CN3 on the TX-RX unit, inserting W2 (3P; green) into CN7 on the TX-RX unit, and connecting the KCT-19 (option) to CN2 and CN3 of the KAP-1.
Modifying the Transceiver Horn alert
The signal from pin 4 of IC9 on the TX-RX unit turns Q5 and Q1 on and off and drives KAP-1 HA relay K2 to drive the horn with a maximum of 2A. The default output is HR1. The relay open output can be obtained between HR1 and HR2 by removing R1 in the KAP1.
R1 HR1 (Default) Yes Output form
04
Installation procedure
1. Open the upper case of the transceiver. 2. Insert the two cables ( 1 ) with connectors from the KAP1 switch unit into the connectors on the transceiver. 3. Secure the switch unit board to the chassis with a screw ( 3 ). The notch ( 2 ) in the board must be placed at the front left side. 4. Attach the cushion on the top of the KAP-1 switch unit.
HR2
No
04 04
1 3 2
4
Cushion / (G13-1710-04) 3
04
" !
W1 W2
04
CN1 CN2 CN3
04
CN3 CN7
KCT-19
Fig. 3 / 4
Fig. 4 KAP-1 foil side view
|
|
 |
> |
|