|
There are currently no product reviews.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
 ;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
;
The Service Manual for Sansui AU-9500 was very helpfull, in complete and in good printable condition.
Thanks.
(2) Press [Yes] button.
2. When LCD Panels are exchanged. Step1. Adjust the VCOM data (front and celing) . This adjustment makes the flicker of a panel into the minimum. Step2. Adjust the Shading data. Step3. Set the new data to the Projector.
2-1 Adjust the VCOM data
(3) Input file name and press [Open] button.
(1) Select [Built in Signal] from [Check] menu. This menu can output the signal pattern built in the projector.
1-4 Set the shading data to the projector (1) Select [set] from [Projector] menu.
(2) Set the color level and press [OK] button (When you adjust Red VCOM, set red level 100%.)
(2) Select commucation port and press [Go] button. After setting press [Close] button.
(3) Select [Vcom] from [Check] menu.
(3) If you save data to the projector press [Yes] button.
1-25
|
