|
There are currently no product reviews.
 ;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
;
Perfect, complete manual, exactly what I needed. Recommended to everyone.
;
Very usefull manual. From my point of view there are needs more clearables images.
;
Once again owner-manual.com has saved the day for me, and come through with the manual I need. I looked other places too, and couldn't find it anywhere. Thank You owner-manual.com!!! You're the BEST!
;
very good quality that can be magnified several times, and it remains readable.
For sure I will return next time the need for a service manual arise.
4. LCD panel drive center voltage adjustment (Perform the
adjustment when replacing main PC board or LCD panel)
When inputting video signal data to the LCD panel, center voltage of specified range is adjusted to output symmetrical wave. If this voltage is out of alignment, the LCD panel is damaged by flicker or burning. So it must adjust completely. R, G and B panels should be adjusted for each front projection mode (Front) and Ceiling hunger projection mode (Ceiling). (1) Start signal generate software (SINGO98.exe) and select the Burst signal to output.
(3) Press [R], [G] or [B] key to select the adjustment. When you press the key, it turns ON or OFF. For example, to display red, press [G] and [B].
R-Burst
B-Burst
(2) Right-click to display the Burst submenu, enter [1] in the line interval box and select [V] in the H/ V.
G-Burst
6
|
