|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
VERY NICE FOR COURTESY AND PRECISION!.
tHE SITE IS VERY IMPORTANT FOR ALL DEVICES
vERY GOOD
;
+++ Is is fine, that was what i looking for. Thanks! +++
;
A very good complete archive, i am very satisfied for document.
 ;
The Service Manual received was helpful. The electronic information is exactly what I needed.
;
The Manual was perfect.
The deliverie was perfect.
Thanks
Chapter 7
Projector Setup
Plug in the power cord; turn on main power switch and the power of the projector.
How to enter to the Factory Mode (TLP-X2500/XC2500/X3000/XC3000)
1) While the Volume adjustment bar is displayed on the screen, set value to [2], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 2) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 3) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 4) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously.
When the projector enters to the Service Mode, the buzzer beeps for 3 seconds. If doesn�t beep, repeat from the beginning. This mode maintains until you turn off the main power switch.
7-3
|
|
|
> |
|
