|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
CONFIDENTIAL
� Error 2 Error message Cause Solution � Error 3 Error message Cause Solution : "There are too many white cracks cannot be rectified." : There is a hardware error. : Replace the camera unit. : "There are many white cracks." : The light is not sufficiently blocked. : Block the light completely and perform white defect correction again.
DRAFT
4-9. ****mode release
When the handset does not turn on and enter the normal mode, use this function to change ****mode to the normal mode. <Operation> 1) Select the COM port on the SPST initial screen and click "****mode release". The following dialog box appears.
2) If SPST cannot communicate with the handset, the following message is displayed. Make sure the handset is turned on and click "Retry". To exit, click "Cancel".
3) When complete, the following message appears.
5. OTHER TESTS
SPST does not provide tests of Bluetooth/USB communication. Check them according to the following instructions.
5-1. USB
Connect TM100 and a PC with a USB cable. Check that TM100 is recognized as a device. If the USB driver for TM100 (SHARP GSM GPRS USB Driver) is not installed on the PC, �Found New Hardware� window appears and �Found New Hardware Wizard� starts (the handset is recognized).
TM100
ADJUSTMENTS, PERFORMANCE CHECK, AND FIRMWARE UPGRADE
2 � 20
|
|
|
> |
|
