|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
SETTING UP
Section 4a
1 to 3mm clearance gap for all 3 chrome pillars 3
Top / Sub / Middle Plinth Assembly Level Adjustment
1 2 3 Carefully insert the 2.5mm A/F Allen key through the Foot Insert and find the TMS 2 �BLOB� adjusting screw hole Once the Allen key has correctly engaged with the �BLOB� adjusting screw, turn the Allen key to raise or lower the Top Plinth Assembly Repeat this procedure with the other two suspension points
4
2
The Sub-plinth, Top plinth & Middle plinth raise and lower together (Ensure that the gap between the chrome pillar top and the top plinth recess is always between 1mm to 3mm and that this gap is approximately the same for all three pillars)
1
NOTE: The Top, Mid and Bottom plinths are custom made of a specially formulated material and may not be exactly flat. These plinths are structural components of the TMS 2 and only their structural properties are important. It is however very important that the Main bearing/Inner platter, the Arm Board and the Pulley are level with each other.
MID PLINTH SUSPENSION SUB-PLINTH TOP PLINTH
TOP PLINTH SUSPENSION RING MOUNT
TOP PLINTH ADJUSTING �BOLB� ASSEMBLY
MID PLINTH TOP PLINTH SUSPENSION MOUNT TOP PLINTH PROGRESSIVE DAMPING SUSPENSION RINGS BOTTOM PLINTH SUB-PLINTH SUSPENSION ADJUSTMENT WASHER SUB-PLINTH SUSPENSION MOUNTS
|
|
|
> |
|
