|
There are currently no product reviews.
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
POWER-ON MESSAGE
Each time you switch the transceiver ON, the factory-default message appears and stays for approximately 2 seconds. You can program your favorite message in place of �KENWOOD�. 1 Press [MNU] to enter Menu mode. 2 Select Menu No. 2 (Front Panel).
CALL PWR
�
To skip by four characters when operating the above control or keys, press [MHz]. Press [MHz] again to quit this jump function.
1 2 3 4 5 6 7 8 9 10 11
7 Press [s]. s
� The second digit blinks.
8 Repeat steps 6 and 7 to enter up to 7 digits.
� � � After entering the 7th digit, pressing [s] causes an error s beep to sound. To re-enter the preceding digit, press [t]. t To clear all digits and move back to the first digit, press [VFO].
VOL
SQL
9 Press [SET] again to complete the setting. 10 Press [MNU] to exit Menu mode. 3 Press [s], then select Item No. 2 (Power On Msg). s
CALL PWR
DISPLAY DEMONSTRATION MODE
By initiating this mode, various pre-programmed displays appear. You still can normally use the transceiver in this mode. Pressing buttons or microphone keys, or turning the Tuning control restores the operating display immediately. If there is no button/key entry or Tuning control adjustment for approximately 12 seconds, the transceiver reverts back to Demonstration mode. Press [F]+ POWER ON to toggle the mode ON or OFF.
12 13 14 15 16 17 18 19 20 21
VOL
SQL
2
1
4 Press [SET].
� The last digit blinks.
5 Press [VFO].
� The cursor moves to the first digit.
6 Turn the Tuning control, or press Mic [UP]/[DWN], to select the first digit.
69
|
