|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
DOOR REVERSIBILITY
To change the direction of opening of the non-clear door 1. Unplug the dryer. 2. Open the door. 3. Remove the contact pin at the upper part of the door with a spanner. Turn the contact pin 90° and take it out. 4. Unscrew the 2 screws at the door hinge and remove the door. 5. To remove the door lock: � Unscrew the two screws above and below the door lock system and slide it upwards (1,5 cm) holding it from the bottom. Remove it. 6. To change the door opening: � Turn the door. � Re-fit the door with the 2 screws at the preferred position. � Insert the door lock system at the opposite side of the door and move it (1,5 cm) down. � Fix the 2 screws above and below the door lock system. � Take care not to reverse the sense of the door lock system. The child safety must be above the locking mechanism. 7. Replace the contact pin in the top of the door.
MAINTENANCE
1. Wipe the cabinet with a mild household detergent. Avoid using abrasive cleaners. 2. Clean the lint filter at the end of each drying cycle. 3. If the lint filter mesh is clogged, clean it with water and a soft brush. 4. Clean the heat exchanger at least every three months proceeding as follows: � � � � � � Open the door and press the button on the bottom of the door entrance. The heat exchanger flap opens. Rotate the retaining springs and extract the heat exchanger. Wipe away fluff from the seal and housing using a damp cloth. Flush the heat exchanger under running water. To replace the heat exchanger, insert it into its bay and lock it in place with the retaining springs.
N.B.
The heat exchanger plates may discolour with use.
5. Wipe away fluff from the door seal and the inside of the door using damp cloth.
22
|
|
|
> |
|
