|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
There are currently no product reviews.
 ;
helpful manual.good service.Quick response.will use again
 ;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
Installing the TSS-SAT4000 Step One
Remove the bottom end cap of the speaker by unscrewing the single center screw (Allen wrench included with satellite).
Step Three
Align and insert the alignment pin into the bottom of the speaker.
Satellite Speaker
Infinity Logo End Cap NOTE: The bottom is the side closest to the Infinity logo on the front grille. 1/4-20 x 3/4" Screw
Step Two
Attach alignment pin to stand, and run speaker wire up stand. NOTE: Needle-nose pliers may be required. Alignment Pin Alignment Pin
|
|
 |
> |
|
