|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
If using more than one subwoofer, always adjust both subwoofers together. Adjust the controls as indicated by the Measurement Template. Each value shown in the table is represented by detents in the R.A.B.O.S. controls. Simply count the number of detents necessary, indicated by the results of your R.A.B.O.S.Test. TSS-SUB4000 R.A.B.O.S. Controls
Final System Balance
Cue Track 51 of the R.A.B.O.S.Test CD. Press Play �. Increase the system volume until the RSLM indicates �10dB. Now play Track 52. Adjust the subwoofer gain control until �10dB is indicated on the RSLM. Of course, you may fine-tune the subwoofer gain control to your listening preference. This concludes the R.A.B.O.S. process. It is recommended that you remove the battery from the RSLM. Store the Test CD, Width Selector, Adjustment Key and the RSLM together.
After performing these adjustments, you may skip forward to the �Final System Balance� section. It is recommended that you perform a second measurement to confirm that the settings are correct. If you are going to retest the system after EQ adjustments, repeat the �Setting the Subwoofer Test Level� section on p. 7. Retesting the system will go much faster if you use Tracks 27�50.These tracks contain all the same test tones you just used. However, each tone plays for only a few seconds and there is no frequency announcement. If you are uncomfortable operating at this pace, you may, of course, perform measurements with the original test tracks. Your first interpretation of the data and choice of settings may not be optimum.You can repeat the test-adjust-test cycle as often as needed to get the desired results.To do this, return to page 7, �Setting the Subwoofer Test Level.� You may prefer to retest using the same template. Doing so makes it easy to evaluate the improvement. When you are satisfied with the results, go to �Final System Balance.�
15
TSS-SUB4000
|
|
|
> |
|
