AIWA TSW45
Owner's Manual

POSITIONING
1
Because low-frequency sound reproduced by the powered subwoofer is mostly non-directional, the listener will be unable to localize the bass source. Accordingly, the powered subwoofer provides maximum flexibility in terms of positioning. For the most

L
,0
$.

,1

If@@

effective low-frequency sound, the powered subwoofer should be placed on the floor close to a wall or in a corner of the room.

CONNECTIONS
Connect the speaker cords before connecting the AC cord. Connect in u way if your stereo system has a SUPER WOOFER output jack. [f not, connect in u way. Never connect in both of

u and u ways

simultaneously.

Ml

\

J

uConnecting

u
m�

.

1

an AIWA stereo system with a SUPER WOOFER or SUB WOOFER output jack (RCA phono jack) to the powered subwoofer

Preparations
Turn off the power of this unit. 1 Connect the SUPER WOOFER or SUB WOOFER jack on the

stereo system side ~ to the INPUT 1 (FROM SUPER WOOFER TERMINAL) jack on the powered subwoofer O with the supplied connecting cord. 2 Set the INPUT SELECT switch to�1�.

u Connecting

a stereo system with typical Land R speaker terminals to the powered subwoofer

u -2,3

-.

Turn off the power of the stereo system and remove the speaker cords from the speaker terminals on the system.

Preparations

1

ID

Connect the stereo system speaker terminals @to the INPUT 2 (FROM SPEAKERS OUT) terminals�on the powered subwoofer @ with the supplied speaker cords 0. Make sure the L and R and the @ and @ cords are connected correctly.

2

Using the speaker

cords

removed switch to �2.

in �Preparations�

above,

Ji2J
0

10 0

3

connect the right and left speakers 6) 0 OUT terminals on the powered subwoofer Set the INPUT SELECT

to the SPEAKERS Q).

Connecting
Connect

the AC cord

the AC cord to a wall outlet.

Use Iefffright speakers whose impedance value specified on the stereo system.

corresponds

with the

6