|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
switch also reverses the polarity of the 1/4� output jack. In the Normal (out) position, the signal is in-phase. In the Reverse (in) position, Pins 2 and 3 are reversed as the signal is changed to 180 degrees out of phase. In multiple microphone applications, the placement of the microphones can affect the phase of a signal. If two microphones pick up the same signal from different locations, the result can be a hollow or frequency �shifted� sound. In some cases it may sound as if an instrument disappears if it happens to be 180 degrees out of phase. Depressing the Phase switch can remedy this problem. Likewise, if a microphone cable is wired incorrectly, when used with a properly wired cable the signal will be out of phase. Note: for single microphone applications, switching the phase switch in and out will produce little to no change in the output signal. Output Level Control The Output Level control sets the output level of the Tube PAC. When the control is fully counterclockwise, there is no output. Turning the control clockwise increases the level of the output to a maximum of +10dB of gain. When setting the Output Level control, refer to the level meter on your recorder or mixer. Bypass Switch A Bypass switch is included on the Tube PAC to enable you to remove the compressor from your signal chain. When set to its �in� (bypass) position, signal is allowed to pass from the preamp circuitry to the output jacks with no compression. The LED will glow red when Bypass is engaged. This informs you that the compressor is bypassed. In its �out� position, the compressor is active. Use the Bypass switch when setting the Tube PAC�s Output Level to achieve unity (no boost or cut) gain. Unity gain is achieved when the active level is the same as the bypassed level.
10
|
|
|
> |
|
