|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual...really saved me. The only problem is that I thought I would be able to download it directly when I paid for it but never received the download instructions until the next morning. The board trace pages were somewhat light also: really need to turn up the contrast on the printer before printing them. The schematic page was great; very clear! Well worth the money.
 ;
I've been in the electronic business for a long time. I used to buy Sam's Photofact for my needs which intailed having to go to the store and paying about $20 for a package of 3 different units so I was forced to buy more than I needed just to get one.
Owner manual is just at your keyboard and the information is almost instantansouly and the cost is very reasonable. Easy to print out if needed or simply read off of the screen. The larger the screen the better for obvious reasons.
;
Very good manual, at a very good price. Received in a timely manner
;
Only thу cover has poor quality, internal material has excellent quality - exactly what I needed
Thanks!
;
Had everything I needed. Onyly took a few hours after paid for by PayPal. The copy was very readable.
9
Remote control buttons in service mode When the receiver is in the service mode you can select normal TV mode by pressing the TV button and return to the service mode by pressing the i button. Number and cursor buttons are used for service adjustments. The OK button stores the settings. The yellow button hides/shows the service menu to simplify the picture adjustments. Making adjustments for different picture formats Make all adjustments with PAL signal unless otherwise mentioned. Make 4:3 set adjustments with normal 4:3(CLASSIC) picture format and 16:9 set adjustments with wide picture format. Then make the necessary adjustments with other picture formats/signals. The required adjustments are shown in the table below. Note! Check the configuration of the TVset before making the adjustments and make only the necessary adjustments. 3. Store the new value by pressing the OK button. Making a service adjustment 1. Give a two digit code which determines an adjustment (e.g. 00 = vertical shift, see the following tables) with the number buttons. You can also select the adjustment with cursor buttons (up-/down). Note! Power supply and UG2 adjustments before picture geometry adjustments. must be done Note! To avoid incomplete adjustments store each adjustment in the memory immediately after an adjustment has been made. If an adjustment has to be made separately for different picture format/signal, select first the normal mode by pressing the TV button and select then the desired picture format/signal. Return to service mode by pressing the i button.
l l
2. Adjust with the cursor buttons (left/right).
Picture
geometry
adjustments
-
r
-
el -
-
-
E
0
5
d
:
i i ; 3 C
2
s ti E
ri
4djustment Jertical off-centre Jertical Jertical Vertical Vertical Vertical Width Horizontal Parabola Corner Trapezium shift deflection amplitude slope S-correction zoom scrolling shift
:ode 00 01 02 03 04 05 06 07 08 09 - 10
OSD
name
9 Ii
K K < X
!z s:
6 iii !i 2
Note! Center line upper lower side part
V-SHIFT V-AMPL. V SLOPE S-cot?!?. VER ZOOM v SCROLL WIDTH H-SHIFT PARABOLA CORNER TRAPEZ
X X X X
K Adjust Adjust
X) Xl
IX (X
Recommended Recommended
to use init value to use init value
first first
X X X
X X
X X
X X -X
X
X
X
-
|
|
|
> |
|
