|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great quality manual, fast service, excellent seller... Thanks !!!
;
Great manual and fast service. Download was possible after a few hours.
;
thanks a lot.
without the service manual my handycam was going to the trash.
good job, go on.
bye
 ;
This service manual is a good copy of the original, complete and fully readable. It is really useful to repair my Tv set following its clear instructions.
;
Excellent quality. Easy process to download. No issues or problems at all - was exactly what I was looking for and needed. Great service.
IC, TA1275AZ Pin No.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
Pin Name
Y OUT MODE SW R-Y OUT R-Y BLACK CONTROL B-Y OUT B-Y BLACK CONTROL S-ID FILTER EXT R-Y IN 5V VCC EXT B-Y IN GND Fo-ADJ FILTER C IN BELL-ADJ FILTER Y IN BELL CONTROL S.C.P. IN 5V VCC 4.43MHz CW IN ID SW SECAM ID I/O
I/O
O O O I O I I I I I I I I I I I I I/O The output pin for Y signal.
Description
The pin for controlling the Y processing mode: to Vcc: 5.5MHz trap ; open: 5.5MHz trap + D.L ; to GND: DL. (not used) The output pin for demodulated R-Y signal. The pin for controlling the black offset level. (not used) The output pin for demodulated B-Y signal. The pin for controlling the black offset level. (not used) The pin for connecting the SECAM ident filter capacitor. The input pin for external R-Y signal. (not used) The Vcc pin for Y/C processing block. The input pin for external B-Y signal. (not used) The Gnd pin. The pin for connecting a capacitor for automatic adjusting circuit. The chroma signal input pin. The pin for connecting a capacitor for the bell filter fo, 4.286MHz. The Y signal input pin. The pin for selecting the bell filter fo. fo + 70KHz: open ; fo + 35KHz : 20k to GND ; fo: to GND.(Connected to Pin 18) The pin to input the sand castle pulse, SCP. Vcc pin for logic block. The pin for input 4.43MHz of carrier wave for self adjustment circuit. The switch pin for selecting the ID detection mode. (Connected to Pin 18) H + V: connected to Vcc ; Auto search: opened ; H: connected to GND. The interface pin to the main processor.
�20�
|
|
|
> |
|
