|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A very easy to understand and use manual. Well worth the money.
 ;
Very good information with clear drawings. Thanks!
;
The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
;
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
;
I am proud of you. In the future, I benefited from your services.
3. TUNER ADJUSTMENT 3-1. AGC Adjustment
(3) Using a DC power supply, add DC3.0V ± DC0.2V of voltage to the IC301 Pin10 (TP14). (4) Make adjustments with L203 so that the waveform�s center section (a section in the figure below) of the ALIGNMENT SCOPE becomes 45.75 MHz ± 50 kHz. (1) Receive a NTSC signal of RF INPUT under the following conditions. Input level: 58 dBµ Modulation percentage: 87.5% Received channel : US TV 10ch (fp = 193.25MHz) (2) Adjust SFR201 so the voltage at the TU101 Pin1 (TP15 or JW101) is 6.8V ± 0.2VDC. (Simple Adjustment Method) (1) Using the LEADER LCG-401 (65dBµ), receive the color bar signal on channel 2. (2) With SFR201, make adjustments so that the voltage of TU101 pin1 becomes 3.6VDC. (3) Receive a television broadcast, and verify that the screen is clear.
45.15
46.35
a
47.75MHz
3-2.
VCO Adjustment
(5) Remove the capacitor.
( Rough Adjustment ) (1) Make connections as they appear below.
3-3.
AC POWER SUPPLY TU 101 Pin ! (TP2, IF)
10 TP14
AFT Adjustment
(1) Connect the resistance of 1 k� between the TU101 Pin11 and the GND.
TU 101 11 TP2 1k�
ATT
IC301 44 TP12
LSW � 480 VIF
ALIGNMENT SCOPE
(2)
Connect between Pin52 and GND of IC301 with capacitor.
(2) Input the following signal conditions to the TU101 Pin11. (AM/FM SSG) CARRIER 45.75 MHz LEVEL 100 dBµ MOD OFF (3) Make adjustments with L206 so that the voltage of the IC301 Pin47 (TP16) is DC4.5V ± DC0.2V. (4) Remove resistance (1 k�). ( Simple Adjustment Method )
IC301 52 + CAP, 10/50 + C207 0.47/50
(1) Using the pattern generator LCG-401, receive the signal for channel 2. (2) Adjust L206 so that the voltage at IC301 Pin47 (TP16) becomes 4.5V ± 0.3VDC. (3) Receive each television broadcasts and vertify that the picture is clear.
33
|
|
|
> |
|
